In the tutorial, we aim to make 100mL of winstrol oil 50mg/ml.
Step 1 - Prepare Ingredients & Tools.
Confirm the recipe we’re going to use. Then we could prepare the ingredients before we start.
According to this post, someone proved it, the recipe we’re going to use for making winstrol oil 50mg/ml is:
1.8% BA
25% BB
100% Miglyol 840 carrier oil.
By using this calculator, we’re going to need:
BA: 1.8mL
BB: 25mL
Miglyol 840: 68.39mL
winstrol raw powder: 5grams
Please prepare the ingredients above and the following:
- A sterile beaker;
- A magnetic stirrer with heating plate, can heat up to 300 °C.
Step 2 - Melting and Stirring.
The melting point of winstrol raw powder is about 242 °C, so we need to heat up to 300 °C.
- Add 5g winstrol raw powder into the beaker.
- Add 25mL of BB into the beaker.
- Heat the raws at about 260 °C until the raws are melted. Keep stirring the conversion and switch the temperature to about 110 °C
- Add 68.39mL Miglyol 840 carrier oil.
- Add 1.8mL BA.
- Keep heating and stirring for 20 minutes.
- Done!
Step 3 - Filtering, fill and crimp.
Filtering the winstrol conversion with sterile filtration membrane device. The filter membrane could be among one of these: PVDF, PTFE or nylon. Pore size should be 0.22μm.
After sterile filtration, fill sterile oils into sterile vials, plug the rubber stopper and seal vials.
We’ve made 7-8 vials of stanozolol / winstrol oil injectables @50mg/ml.
Thanks for reading! Let me know if you got any questions.
